Produktübersicht
Der AutomationDirect DirectNET-Gerätetreiber ermöglicht in Verbindung mit dem KEPServerEX den Datenaustausch zwischen OPC-Clients und DirectNET-Protokoll-konformen SPSen. KEPServerEX optimiert die Datenerfassung automatisch auf Grundlage der Clientnachfrage. Die Datenintegrität wird durch umfassende Fehlerbehandlung sichergestellt.
Ressourcen
Leistung
- Ethernet-Kapselung
- Unterstützung sämtlicher Datentypen
- Modemunterstützung
- Konfiguration von automatischem Wählen
- Verwaltung mehrerer Telefonnummern
Protokolle
- Koyo DirectNet Hex Mode Protocol
Unterstützte Geräte
- DL-05
- DL-06
- DL-230
- DL-240
- DL-250
- DL-260
- DL-330
- DL-340
- DL-350
- DL-430
- DL-440
- DL-450
Anwendungsunterstützung
- DDE Format CF_Text and AdvancedDDE
- NIO Interface for iFIX
- OPC .NET Service (OPC .NET) Version 1.00
- OPC Alarms and Events (OPC AE) Version 1.10
- OPC Data Access (OPC DA) Versions 1.0a, 2.0, 2.05a, and 3.0
- OPC Unified Architecture (OPC UA) Clients
- SuiteLink and FastDDE for Wonderware
Versionshinweise
6.11.718.0
21.12.2021
- Fixed an issue that prevented all communications with devices.
6.10.659.0
10.08.2021
- Fixed an issue that prevented the driver from communicating with devices.
5.17.495.0
24.02.2015
- Corrected an issue where the driver would produce a syntax error during tag validation if the data type was not supported. Some clients add items with a set data type regardless of the address. The driver now responds with bad type, allowing the driver library to validate again with the default type.
- Fixed an issue where Data Words Timers (V0-V377) and Counters (V1000-V1177) default to the BCD data type even if the address was a bit within data type; bit within BCD is not supported. For V addresses with bit-access syntax, the driver now defaults to the Short data type for the bit range 0 to 15 and to the Long data type for bit range 16 to 31.
5.6.122.0
25.07.2011
- Enhanced error handling when receiving unexpected responses, and special detection of a K-Sequence response to a DirectNet inquiry. On receiving a K-Sequence response to a DirectNet inquiry, an error message will be logged, all tags will be failed, and the driver will continue to silently retry for good communications.
