検索機能を使用して 500 を上回る Kepware の知識ベース記事の中から閲覧します。結果を絞り込むか、クエリーを下部の検索フィールドに入力します。

解決策が見つからなかった場合には、当社の PTC eSupport Portal で追加資料を確認することもできます。eSupport Portal へのログインを要求された場合、My Kepware の認証情報を使用できます。My Kepware アカウントが必要ですか? こちらで作成

各種検索方法:
View All Solutions

Kepware Knowledge Base: Solution


Does KEPServerEX Support Communications with the Horner XLe-Series OCS?


Last Update: 2018/11/07

Yes, it does. The Horner XL4e Series has an embedded Ethernet port over which the device supports functioning as a Modbus TCP slave. This means that Kepware's Modbus TCP/IP Ethernet driver can be used to communicate with the device.

With older models, the XEC (Ethernet) module should be used. This module works with Kepware's Modbus RTU Serial driver using a virtual COM port or Ethernet Encapsulation.

Note: Because the XLe Series does not support the OCS protocol based on GE Ethernet, the GE Ethernet driver cannot be used. With older XLe models, users may forgo XEC and get the standalone Horner OCS driver from the device vendor at http://www.heapg.com/. This product supports the CsCAN network, which requires that a special card be installed in the PC. Kepware does not sell or support this product directly.

Related Protocols
Modbus Ethernet