検索機能を使用して 500 を上回る Kepware の知識ベース記事の中から閲覧します。結果を絞り込むか、クエリーを下部の検索フィールドに入力します。

解決策が見つからなかった場合には、当社の PTC eSupport Portal で追加資料を確認することもできます。eSupport Portal へのログインを要求された場合、My Kepware の認証情報を使用できます。My Kepware アカウントが必要ですか? こちらで作成

各種検索方法:
View All Solutions

Kepware Knowledge Base: Solution


Does KEPServerEX Support Communications with the Netcon 5000 from Woodward?


Last Update: 2018/11/07

Yes, it does. The Modbus Serial driver can be used in Ethernet Encapsulation mode, which is different than using the Modbus Ethernet Driver. For more information, follow the instructions below.

Note: All parameters should be left at their default settings unless an alternate value is stated.

  1. In the Netcon 5000 configuration file, find the function block that determines the port setting. Note this number, since it will be needed in a future step.
  2. Next, add a channel to the server project. In the Device Driver drop-down menu, select Modbus RTU Serial and then click Next.
  3. In Communications, select Use Ethernet encapsulation and then finish defining the channel.
  4. Next, add a device to the channel. In Ethernet Encapsulation, enter the Netcon's IP address and then edit the port number to match the number set earlier in the Netcon 5000 configuration file. Then, choose UDP as the protocol.
  5. In Framing, make sure that the Use Modbus TCP framing checkbox is not checked. Then, finish defining the device.
  6. Users should now be able to communicate with Netcon 5000.

Note: Newer versions of Netcon firmware also support TCP.

Related Products
Modbus Serial, Modbus Suite