検索機能を使用して 500 を上回る Kepware の知識ベース記事の中から閲覧します。結果を絞り込むか、クエリーを下部の検索フィールドに入力します。

解決策が見つからなかった場合には、当社の PTC eSupport Portal で追加資料を確認することもできます。eSupport Portal へのログインを要求された場合、My Kepware の認証情報を使用できます。My Kepware アカウントが必要ですか? こちらで作成

各種検索方法:
View All Solutions

Kepware Knowledge Base: Solution


Unable to Make Remote OPC DA Connections to the Server


Last Update: 2018/11/07

Problem:
Users are unable to make remote OPC DA connections to the server.

Solution:
KEPServerEX administrators must configure Windows security (including DCOM authentication) for remote OPC DA connections to the server to be successful. For information on configuring Windows to permit remote OPC DA connections, refer to "Remote OPC DA Quick Start Guide".

Note: If the OPC DA client is running as a non-administrative user, KEPServerEX administrators may need to add it to the list of approved users under OPC Enum's Launch and Activation Permissions. For more information, refer to the instructions below.

  1. Log in as an administrative user on the client machine.
  2. Next, launch Component Services by clicking Start | Run | DCOMCNFG.
  3. In the left-hand window pane, expand Component Services | Computers | My Computer | DCOM Config.
  4. Locate and right-click on the OpcEnum entry in the list. Then, right-click and select Properties.
  5. Select the Security tab and locate Launch and Activation Permissions. Ensure that Customize is selected and then click Edit.
  6. Add the restricted user to the permissions list, allowing the user full access.
  7. Next, click OK. Then, click OK again to close the OpcEnum Properties window.
  8. Restart the OpcEnum service via the Services program (located in the Administrative Tools in the Control Panel).