検索機能を使用して 500 を上回る Kepware の知識ベース記事の中から閲覧します。結果を絞り込むか、クエリーを下部の検索フィールドに入力します。

解決策が見つからなかった場合には、当社の PTC eSupport Portal で追加資料を確認することもできます。eSupport Portal へのログインを要求された場合、My Kepware の認証情報を使用できます。My Kepware アカウントが必要ですか? こちらで作成

各種検索方法:
View All Solutions

Kepware Knowledge Base: Solution


What Driver Is Used to Connect to the Serial Port of an H2 or H4 EBC module


Last Update: 2018/11/12

Although the Serial port can be configured to connect to a protocol, Kepware does not have any drivers designed to connect to it via Serial.

  • KEPServerEX ->> (via serial) ->> EBC Serial port. This configuration is not supported.

If the port is set up for proxy mode, then users could connect an ASCII device to it and read and write data from/to that ASCII device using the AutomationDirect EBC driver.

  • Kepware's AutomationDirect EBC driver ->> (via Ethernet) ->> EBC (controller module) ->> (via serial) ->> other device

The serial-port tags in the AutomationDirect EBC driver only allow direct low-level access to the EBC's Serial port. The client application will have to take care of all Serial protocol details for any device (like barcode scanner or label printer) connected to the Serial port. For information on accessing the Serial port, refer to the AutomationDirect EBC driver product manual.