検索機能を使用して 500 を上回る Kepware の知識ベース記事の中から閲覧します。結果を絞り込むか、クエリーを下部の検索フィールドに入力します。

解決策が見つからなかった場合には、当社の PTC eSupport Portal で追加資料を確認することもできます。eSupport Portal へのログインを要求された場合、My Kepware の認証情報を使用できます。My Kepware アカウントが必要ですか? こちらで作成

各種検索方法:
View All Solutions

Kepware Knowledge Base: Solution


How Do Snapshots Work with Triggers?


Last Update: 2018/11/07

Snapshots can only be configured for Absolute and Exception trigger types, which are used to place the log group in and out of a triggered state based on specified conditions. A snapshot logs the values that the server holds for log items when the log group enters or departs a triggered state. The two snapshot options are Start Snapshot and Stop Snapshot, and either one or both can be selected. The following scenarios describe how snapshots would be handled. The scenarios assume that the trigger has both start and stop snapshots enabled.

  • The log group is disabled and the trigger condition has not been met when the log group is enabled. No snapshot will be taken.
  • The log group is disabled and the trigger condition has been met when the log group is enabled. A snapshot will be taken.
  • The log group is enabled and the trigger condition has not been met when the log group is disabled. No snapshot will be taken.
  • The log group is enabled and the trigger condition has been met when the log group is disabled. A snapshot will be taken.
  • The log group is enabled and the trigger condition to a triggered state. A snapshot is taken.
  • The log group is enabled and the trigger condition changes to a non-triggered state. A snapshot is taken.

The reasons to use a snapshot vary, but they are used most commonly when there is anticipation that the data in the log group may not be logged for some time after entering the triggered state. The snapshot ensures that the data is logged at least once.

Related Products
DataLogger